New Arrivals/Restock

Seco-Larm SD-9163-KSQ Outdoor Wave-to-Open Sensor – Slimline – English

flash sale iconLimited Time Sale
Until the end
15
20
47

$18.06 cheaper than the new price!!

Free shipping for purchases over $99 ( Details )
Free cash-on-delivery fees for purchases over $99
Please note that the sales price and tax displayed may differ between online and in-store. Also, the product may be out of stock in-store.
New  $45.15
quantity

Product details

Management number 205069812 Release Date 2025/10/16 List Price $27.09 Model Number 205069812
Category

The ENFORCER Outdoor Wave-to-Open Sensor is a full-featured exit plate which uses IR technology to allow egress from a protected area or activate a device with the simple wave of a hand. Since no touch is required, this sensor is suitable for use in hospitals, clinics, labs, cleanrooms (to reduce the risk of contamination), schools, factories, or offices.

  • Adjustable sensor range up to 7″ (18cm)
  • Weatherproof (IP65) for outdoor use*
  • Stainless steel plate
  • 1.2A relay, adjustable trigger duration 0.8~30 seconds or toggle
  • LED illuminated sensor area for easy identification
  • Selectable LED colors (turns from red to green or green to red) to show sensor activated

​*when properly installed

 

Specifications

Type “Wave-To-Open” Request-to-Exit Plates with Adjustable Delay Timer, for Outdoor Use
Current Draw Standby- 16mA@12VDC / 25mA@24VDC, Triggered- 25mA@12VDC / 32mA@24VDC
Sensing Range 2″~7″ (5~18cm)
Operating Voltage 12~24 VDC
Reaction time 10mS
LEDs – Red Standby (Colors are reversible.)
LEDs – Green Triggered (Colors are reversible.)
Relay Type Form C dry contact
Output Time 0.5~30 s, toggle
Switching Capacity 1.2A@24VDC
Operating Temperature -4°~131° F (-20°~55° C)
Dimensions 4-1/2″ x 1-1/2″ x 1-1/2″ (115 x 39 x 39 mm)
Weight 61g
Enclosure Weatherproof IP65

 

Troubleshooting

Sensor is triggering unintentionally.
  • ENFORCER Outdoor Wave-to-Open Sensors can be used either indoors or outdoors. However, due to infrared technology limitations, it is recommended that a hood or shield be used when installing outdoors to shield the sensor from direct light (sunlight, reflections from shiny objects, etc.). Direct light may cause the sensor to trigger unintentionally.

Correction of product information

If you notice any omissions or errors in the product information on this page, please use the correction request form below.

Correction Request Form

Product Review

You must be logged in to post a review