Lectrosonics HMa Digital Hybrid Wireless UHF Plug-On Transmitter, B1 537.600 - 607.950 MHz

Lectrosonics HMa Digital Hybrid Wireless UHF Plug-On Transmitter, B1 537.600 - 607.950 MHz

This unique plug-on transmitter design will ideally match any microphone or line level source via a standard XLR connector. Phantom power is selectable at 5, 15 and 48 volts, or can be turned off for use with dynamic microphones and line level signal sources.

The design includes a wide tuning range of up to 76 MHz, with tuning steps in increments of 100 kHz or 25 kHz, (19 MHz for block 941 version, for 695 frequencies).

Along with providing peerless audio quality with wide frequency response and dynamic range in Nu Hybrid mode, the technology used in the HMa includes compatibility modes for Lectrosonics Mode 3 and IFB receivers.

Key Features

• Accepts audio from any microphone or audio source with an XLR connector
• Selectable 5, 15, 48 volt phantom power
• 76 MHz tuning range in 100 kHz or 25 kHz steps for up to 3072 frequencies
• (941 band offers 695 frequencies over 19 MHz tuning range with 25 kHz steps)
• Selectable 50/100 mW output power
• Adjustable low frequency roll-off
• Powered by two AA batteries
• USB port for firmware updates
• IR (infrared) port for fast setup
• Solid machined aluminum housing

Technical Specifications

Operating Frequency Range
Band A1 470.100 - 537.575
Band B1 537.600 - 607.950
Frequency Selection Steps
Selectable; 100 kHz or 25 kHz
RF Power output
Selectable 100 or 50 mW
Compatibility Modes
Nu Hybrid, Mode 3, IFB
Pilot tone
25 to 32 kHz; 5 kHz deviation (in the Digital Hybrid mode)
Frequency stability
± 0.002%
HMa/E01/E02/941/X
60 dB below carrier
Compliant with ETSI EN 300 422-1 v1.4.2
Equivalent input noise
-125 dBV (A-weighted)
Input level
Nominal 2 mV to 300 mV, before limiting.
Greater than 1V maximum, with limiting.
Input impedance
1K Ohm
Input limiter
Dual envelope “soft” limiter; greater than 30 dB range
Gain control range
55 dB; panel mounted membrane switches
Operating temp. range
Celsius -20° - 40°
Farenheit -5° - 104°
Modulation indicators
Dual bi-color LEDs indicate modulation of -20, -10, 0, +10 dB referenced to full modulation
Frequency Response
35 Hz to 20 kHz (+/-1dB);
Low frequency Roll-off
Adjustable for -3dB @30, 50, 70, 100, (120 or 150 Hz)
THD
0.2% (typ. 100 Hz to 20 kHz
Input Dynamic Range
125 dB (with full Tx limiting)
Controls & Indicators
Power/Phantom “ON-OFF”
Phantom voltage selector
Audio input gain
LCD w/membrane switches
LED audio level indicators
Audio Input Jack
Standard 3-pin XLR (female)
Phantom Power
5V @ 18 mA max., 15V @ 15 mA
max. and 48 V @ 4 mA max., plus “OFF”
USB port
Used for firmware updates
IR (infrared) port
For quick setup by transferring settings from an IR enabled receiver
Antenna
Housing and attached microphone form the antenna
Battery
Two 1.5 Volt AA alkaline
Battery Life (Duracell Ultra):
AA alkaline; No Phantom Power 5h 0m*
AA alkaline; 48V Phantom Power 3h 30m**
* Tested with a dynamic microphone
** Tested with a Sanken CS1 for a phantom-powered microphone
Weight
6.7 oz (190 grams) without batteries
Dimensions
4.25x1.62x1.38 inches
107.95x41.15x35.05 mm
Emission Designator
A1 44K3F3E
B2 57K9F3E
Included Accessories
2 - AA Alkaline Batteries
1 - HM Pouch (Part #PHTRAN3)
1 - Quickstart Guide